DIN 8287-1983 主弹簧.概念、要求、检验

上一篇: DIN 31672-1983 滑动轴承的质量保证.滚动轴套的内外径检验
下一篇: DIN 71988-1983 摩托车的绳索传动装置.轴套.不用于新式结构

【英文标准名称】:Connectorsforelectronicequipment-Part2-103:circularconnectors-Detailspecificationforarangeofmultipoleconnectors(type'XLR').
【原文标准名称】:电子设备连接器.第2-103部分:圆形连接器.多杆连接器系列(XLR型)的详细规范
【标准号】:NFC93-406-2-103-2004
【标准状态】:现行
【国别】:法国
【发布日期】:2004-08-01
【实施或试行日期】:2004-08-20
【发布单位】:法国标准化协会(AFNOR)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:电插头;低频工程;详细规范;规范;圆形连接器;直流电压;插接件连接;电子设备
【英文主题词】:
【摘要】:
【中国标准分类号】:L23
【国际标准分类号】:31_220_10
【页数】:36P;A4
【正文语种】:其他


Product Code:SAE J1937
Title:Engine Testing With Low-Temperature Charge Air-Cooler Systems in a Dynamometer Test Cell
Issuing Committee:Emissions Systems Forum Committee
Scope: The methods presented in this SAE Recommended Practice apply to the controlled testing of low-temperature charge, air-cooled, heavy-duty diesel engines. This document encompasses the following main sections: a.) Definitions of pertinent parameters; b.) Vehicle testing to determine typical values for these parameters; c.) Description of the setup and operation of the test cell system; and d.) Validation testing of the test cell system. While not covered in this document, computer modeling of the vehicle engine cooler system is recognized as a valid tool to determine cooler system performance and could be utilized to supplement the testing described. However, adequate in-vehicle testing should be performed to validate the model before it is used for the purposes outlined. The procedure makes references to test cycles that are prescribed by the United States Environmental Protection Agency (US EPA) and are contained in the Code of Federal Regulations. The existence of other international test cycles, which can be used for validation testing, is acknowledged.